Remove the masking tape.
How to install glass door handle.
Position the inner handle on the inside of the shower door opposite the outer handle.
Place the corresponding doorknob or lever on the interior side of the door fitting the two parts together.
Using a screwdriver and screws provided in the handle kit screw the inner and outer handles together.
You can then remove the masking tape.
Complete the installation by installing the door closer.
You can swap out the handle in about 10 minutes.
Line up the interior glass shower door handle with the exterior one and screw them both into place.
Typically two mounting screws hold the old handle together.
Align the shanks of the inner handle to the holes drilled in the glass door and the shanks of the outer door handles.
It should feel slightly snug when the two parts join.
This project is basically as simple as how to replace a door handle.
Slide the expander off the bottom of the door and install the sweep.
The handles are either single knobs or a handle with multiple connection points to the glass door.
While it is much easier to replace your sliding patio door handles with handles that are exactly the same you can also try using different replacement handles which may need a few holes drilled in the door to improve it.
For a single handle the same principles apply but you will be attaching an end cap in place of an inner handle.
You ll see three vertically spaced mounting holes in the screen door wood doors may require different hardware.
Position the sweep so its weather stripping touches the sill and screw into place.
Remove the screws and discard the old handle photo 1.
Loosen or tighten as necessary.
To replace the handle you will remove the end caps using pliers.
Install the handle set and associated hardware of the new door lock.
Once the exterior door handle is in place you ll want to keep it secure using masking tape.