2016 ironridge inc.
Ironridge roof mount installation.
Ironridge makes solar stronger.
What if i have a class c roof but the jurisdiction now requires class a or b.
Ironridge tilt mount supports a wide range of solar panel tilting angles while also resisting the extreme wind and snow forces experienced over a building s lifetime.
Insert epdm rubber washer over hanger bolt into block using rack kit hardware secure l foot to the mount.
The attachment kit uses an 8 minimum galvanized strut channel with slotted holes to span across two chassis and a flat roof attachment fra anchor in order to anchor the chassis to the roof.
Mount south tilt leg assembly to southern row of roof attachments.
All of our products are fully certified code compliant listed to ul 2703 and backed by a 25 year warranty.
Drill 1 4 pilot holes and backfill with approved sealant.
Build strong and efficient solar arrays on flat roofs.
Tighten flat roof attachment hardware to 250 in lbs.
Tilt mount systems are certified with type 1 modules.
Version 1 10 flush mount installation manual 7 flashfoot locate roof rafters and mark locations on roof.
Drill 1 4 pilot holes then fill with roofing manufacturer s approved sealant.
If using a third party roof attachment refer to manufacturer s instructions for proper tightening torque.
Rain wind and snow.
Secure l feet onto the chassis by installing the carriage bolt and square washer from the underside of each chassis through the reference hole.
We design and manufactures structural hardware for residential and commercial solar systems.
Tape measure chalk line stud finder roofing bar caulking gun driver with 1 4 bit and 7 16 hex socket.
Every component in the system is made with aluminum and stainless steel to ensure complete corrosion resistance.
Our rigorous approach has led to unique structural features such as curved rails universal fastening objects and reinforced flashings.
Torque to 156 in lbs.
Prepare hanger bolt with hex nut and sealing washer insert into hole and using 1 2 socket drive hanger bolt until fully seated and qblock stops rotating easily.
Every component in the ironridge flush mount system has been tested to the limit and proven in extreme environments.
The ironridge logo should face east to ensure proper south leg orientation.
Ironridge is currently class a certified for flush mount applications parallel to roof with type 1 and 2 modules.
The tilt mount system is listed to ul 2703 and compatible with most roof anchor products.
Ironridge bridges these two approaches attached and ballasted by certifying our flat roof attachment a high strength cast aluminum attachment for use on our ballasted system.
