Installing Vinyl Board And Batten Siding Around Windows

Like many types of siding you ll start installing the board and batten panels from one side.

Installing vinyl board and batten siding around windows.

Installing around windows doors cut outs when measuring board batten panels to be cut and installed around windows doors and other cut outs it is important to leave 1 4 gap on the top bottom and sides. Then you can hang the j channel to hold the siding in place at the top and bottom of the wall and also around all windows and doorways. Nail the strips to framing members. Establish your base line.

This will maintain enough room for vertical expansion and contraction and ease of installation. Make sure to check your local building codes to ensure you allow enough space between the bottom channel and the ground. There are so many how to install vinyl siding videos out there i didn t see the point in maki. Nail 4 by 8 foot panels to wall studs with a hammer and 3 inch galvanized nail to penetrate a half inch in the studs.

Also for best results use aviation snips when cutting the j channel. If your sheathing is not solid plywood or osb these strips are needed to provide a nailing surface. Installing window and door trim to trim windows and doors install j channel along the top and sides of the door casings and around windows. If needed install horizontal furring strips every 12 or a solid nail able sheathing prior.

5 key points for installing board batten vertical vinyl siding 1. Use uncoated xps with fiberglass bats that have a vapor before installing inside the wall. Isolate panel style board and batten vinyl siding walls with extruded polystyrene xps rigid foam usually 1 1 2 inches thick. Attach strips around windows and doors then lay out and attach horizontal strips every 16 inches.

If you are installing j channel around replacement windows that do not have nail flanges flash the window before you trim it. It s finally time to install the vinyl siding on the garage. How to install vinyl board and batten siding yourself. The next panel will fit over the edge of the previous one disguising the nailing strip and lock securely into place.

To establish the vertical starting base use a chalk line and a level to obtain a.