Using a measuring tape measure 35 inches 89 cm up from.
Installing rolled roofing tips.
Installing the rolled roofing 1.
It not only protects the roof but it also protects the fascia.
For this heat up the gas burner and push it to the edge of the site where it will be fixed.
Install roll roofing when the temperature is at least 50 degrees fahrenheit to keep the material from cracking.
Here are a few tips that will help you in the process.
Fix edge fabric roll.
Apply roofing cement to the roof.
10 easy steps for diy rolled roofing installation 1 spend some time cleaning the roof before beginning a rolled roofing installation project.
To install roll roofing you ll need to cut the material into long strips of the correct length for your roof and lay it flat.
Spread the roofing cement along the.
3 take a roll of 18 inch wide roofing and use it to cover the length of the valley.
This aluminum flashing protects the edges of the roof sheathing from water.
Snap a chalk line as a guide for the first layer roofing.
Position the first course so it overhangs the drip edges by about 1 4 inch and roll it out a.
Tips for installing roll roofing follow these tips to make sure your new roof goes down smoothly.
If you must install it when it s colder you will want to warm the roof rolls before you start.
How to do it attach first course.
It s best to install the roof when the roof when the temperature is above 45 degrees.
It is also advised to install a drip edge along the roof s edge.
The strips should always be horizontal.
Clean the roof area of any sticks or small stones as over time they may poke holes through the roll roofing material.
Cut the sections of flashing with tin snips as needed and nail.
For extra durability you may install roll roofing in two layers.
Install roll roofing measure 35 inches up from the eaves at several intervals along the roof and mark them.
2 like any other roof project you should start this one by addressing the valleys.
Use a trowel to scoop up the roofing cement.
Roll roofing can be more delicate than other materials.
The roll is unwound and laid on the site of the future installation.
Plan so that no two butt joints are closer than 2 feet from each other.
Cut the rolled roofing.
Do not use the eaves as a guide instead because they can be uneven.
Drip edge or drip cap is either plastic or sheet metal.
To seal a plumbing vent spread roofing.
It also helps if you first install a layer of roofing felt.
Attach it to the valley with roofing nails spaced 6 inches apart about 3 4 inch from the edge.
Install peel and stick roofing in a similar manner.
Mark a chalk line to identify the end of your first layer.
