Make the most of all of that space in your roof with an attic ladder.
Installing attic steps.
Cut out the framing around existing hatchway opening with a reciprocating saw.
In most cases you ll need to drill a pilot hole and install a hex head cap screw and lock nut to keep the foot in place.
Measure 54 inches and tap the second nail next to the same joist image 1.
The ladder length will depend on your ceiling height.
Improper installation may result in serious injury.
Lowe s will coordinate your attic ladder installation service to remove your old attic ladder handle your new attic stair installation and haul away the old unit.
Installation requires two people.
Use a reciprocating saw to cut joists and nails holding any joists that must be removed.
Cut out the ceiling joist and any wood blocking that s in the opening.
Mark rough opening of new fold down staircase on the ceiling joists in the attic.
Whether you already have an existing cavity in your roof or need to create a new one t.
How to install an attic ladder step 1.
Cut around ceiling trim with a utility knife.
Measure and cut.
So stop worrying about how to install an attic ladder and let lowe s coordinate your attic stairs installation.
Using a reciprocating saw start your cut by lightly tapping the blade into the drywall and cut along the chalk.
Read and follow the manufacturer s instructions for your attic stair model.
Contact lowe s today to help with installing attic ladders or.
Make sure the foot pads touch the floor and provide a.
Snap a chalk line between the two.
Remove joists and other obstructions.
Snap chalk lines onto the ceiling to represent the rough opening of the attic staircase.
Then thread the washer included in the attic ladder kit onto the rope on the upper side of the door.
Install the attic ladder feet as instructed by the manufacturer.
Ensure that you have the right size ladder and that there s suitable landing space in the attic for safe mount and dismount from the ladder.
Construct the opening.
Attach rope install the pull rope on the ladder assembly by threading the rope through the hole in the door.
If you have a pull down attic ladder installed and only need to replace the stairs good news for you you can skip this step.