Install Recessed Lighting In Existing Ceiling No Attic Access

But some homeowners may be reluctant to install them if they don t have access to attic space above the room where they would like to have the can lights installed.

Install recessed lighting in existing ceiling no attic access.

How to install recessed lighting even without attic access materials needed. Run electrical cable through the ceiling from the recessed light hole over to the light switch hole. Watch the entire process step by step. Its wires are held inside an electrical box that is connected to a metal light can.

Remodeling recessed lights also found on amazon pencil. With a utility knife cut off 3 inches from the outer insulation jacket of each end of the electrical cable to expose the internal insulated wires and bare copper grounding wire. Mark the spot on the ceiling where the recessed lighting fixture is to be installed. Recessed can lights are flush mounted with the ceiling.

Drill a 1 4 inch hole in the ceiling at the center of the proposed opening. Cut the cable with wire. Insert the electrical cable into the cable clamp on the remodelling recessed light housing. Without an attic recessed lights must be installed from below the ceiling instead of the top.

Recessed lights commonly called can lights offer a pleasing finish to virtually any room and make for a reliable source of inconspicuous lighting. Use an electronic stud finder to locate two adjacent rafters and mark a spot half way between them as the. Pull the end of the cable out of the wall by 6 inches with fish tape. When the can is installed into the ceiling clamps on the side expand securing the fixture.

Unfortunately though a retrofit installation for those of us without attic access can also get pretty expensive if you hire someone to do the work for you. If necessary go into the attic and make sure there are no wires pipes or ductwork behind the proposed opening.