Prepare the area where you will install the roof flashing.
Install flashing roof to awning.
Begin by removing the shingles at the affected area and removing old flashing if present.
How to install porch roof flashing.
Try to keep the nails as flush as possible to the edges.
Then nail the new l shaped flashing under the builder s felt but above the fascia board.
Method 1 installing an awning patio roof onto existing fascia.
I cut the tape so that it laps onto the housewrap above and 3 in.
The final thing to do is install the end wall trim.
Measure the length of the porch roof joint to determine how much flashing you will need.
Flexible flashing tape seals the eave to the wall.
Installing onto a beam that mounted to the top plate of your external house frame through the roof.
This video shows how to install endwall flashing with standing seam panels.
Nail the flashing securely in place using roofing nails.
The video features union s advantage lok ii standing seam roofing panel which is.
Above the roof sheathing.
Use roofing nails to install the l shaped flashing flush with the roof and wall then cover it with roofing cement and reattach the roofer s felt.
Place the flashing between the joint of the house and the roof.
After installing the brackets the installation process of the awning can vary based on the awning itself as well as the type of mounting.
Also take time to properly seal all edges of the mounting brackets with high quality silicone sealant.
Before we install the end wall flashing we have to apply tape sealant to the top of the z trim so that there s a water tight barrier between the end wall flashing and the top of the z.
When installing the roofing to the fascia it will either go under the exiting roofs gutters or the gutters will need to be taken off and the existing roof can either be extended.
Nail the upper edges of the flashing to the roof sheathing where the shingles were removed with 6 penny.
The flashing on the wall should be flush against it and the porch roof portion should be on top of the shingles.
If you already have faulty flashing installed you must remove it.
Position the flashing with the lower edges atop the carport roof panels along the transition.
