While a drip edge is about 2 1 2.
Install apron flashing gutter.
Gutter apron is installed over the roof edge and hangs in the gutter.
Gutter aprons take on an additional role by hanging down an inch or so into the back of the gutter to prevent water from dripping or splashing behind the gutter.
Second step flashing needs to extend 8 to 14 inches above the shingles according to the national roofing contractors association nrca.
How to install gutter flashing.
Irestore roofing restoration are the indiana experts in the gutter apron and flashing installation industry.
30 degree white aluminum.
Position a ladder on the ground at any corner of the house.
The gutter lip and the apron lip go together so essentially you are extending the back of the gutter by 1 11 4 high.
Drop with 1 4 in.
A gutter apron is used where shingles are not far enough from the edge of the gutter.
Protects fascia board finishes the roof line and guides run off into gutters.
Measure all the sides of the roof line of the house with a tape measure and record the measurements.
A gutter apron is installed on the corners above roof decking.
It is put under the shingles of an attic to flow water directly into the gutter.
First step flashing must be installed before the siding so that the siding can cover the top of the flashing.
Finish your roof line and protect the fascia board with the amerimax 10 ft.
White aluminum roof apron flashing.
Nailing edge 1 3 4 in.
Use tin snips to cut the gutter apron flashing roll in two 3 in.
If your home center or hardware store doesn t sell pre bent flashing ask an aluminum siding contractor or local sheet metal fabricator to bend some for you.
If there s a drip edge installed where the fascia meets your shingles and the gutter is hung below the drip edge get some roll flashing and tuck it up under the drip edge and over the top of the gutter.
Install by nailing under shingles.
Home centers sell rolls of 6 in.
Is it a proper install.
Add all four sides together for the.
At ryan they also have flashing called a gutter apron which actually is about 1 11 4 which and has a lip also on it.
The flashing helps guide run off away from shingles and into the gutters.
What is a gutter apron.
A couple picture are attached are there the proper aprons.
A gutter apron is a long piece of metal fold that starts under the first course of shingles and hangs over the sheathing of the roof.
When it comes to gutter apron and flashing installation there is only one indianapolis area gutter apron and gutter flashing installation specialist that you need to rely on the most.
Gutter aprons take on an additional role by.
Gutter apron a specialized drip edge designed to direct water into the gutter system.
While on the other hand a drip edge is installed to the trim and usually hangs directly behind the back of the gutter.
With gutter replacement you can prevent water from running behind your gutters by installing a metal gutter apron flashing under the shingles and over the back edge of the gutter.
