How To Install Metal Roofing On A Steep Roof

Align the first metal roofing panel so that it overlaps the edging by 1 2 to 3 4 of an inch and is square to the roof line.

How to install metal roofing on a steep roof.

Preparing for a safe job on a steep metal roof requires an assessment of the roof before the job begins. Adhere the joint where the cut edges of the shingles meet the dome with roofing tar. A roofing harness provides the extra security you need when working on such a roof. And for any exposed fasteners try to avoid over tightening them.

Moreover try to ensure that the screws are all aligned evenly. Be sure the larger edge is laid so that the small edge of the next panel will overlap it. It isn t hard as long as you are careful take your time do it right and be safe. Try to space the screws about 12 inches apart down the entire piece of metal.

The edging or eave flashing consists of metal strips that are used to cover the perimeter of the roof. Cut the shingles to fit around the flange s dome. A careful inspection will identify potential hazards and will give. Adhere the shingles adjacent to the flange with roofing tar.

You will use metal roofing screws to secure the metal panels to the sheathing. Some roofs are so high and so steep that even working from scaffolding can be dangerous. Take your first sheet of. Always begin working at the point with the longest peak to eave distance.

Install the roofing screws vertically along each rib in the panel. If the plumbing vent is close to the peak of the roof lap the shingles over the peak of the roof.