How To Install Garage Door Installation

Center and level the first section after you install the brackets.

How to install garage door installation.

At one side of the doorway slip the vertical track onto the rollers of the first door section. Stand the bottom door panel on the floor in the garage doorway. 3 install the rollers and any necessary brackets on the garage door section and any wall or jamb mounted brackets according to the manufacturer s directions. Installing a garage door step 1.

Repeat at the other side. Measure the various areas where the door will be installed. You ll need to release the tension in the torsion spring before you begin working on the garage door. Placing the first panel and track 1.

Use impact driver to mount hinges to the bottom panel of garage door. Screw cable brackets to the door to secure the weather stripping. Install the second. After the tension has been released disconnect the existing garage door opener from the door.

Begin installing your new door. Use a tape measure to carefully record the length and width. The rubber gasket on the bottom section will fill the gaps created by an unlevel floor. Attach weather stripping to the bottom edge of garage door.

To hold the level in place tape it to the section. Door opening height and width headroom from top of. Insert rollers into the brackets attached to the door. Once the piece is in.

Lay weather stripping over the bottom door panel. At a home improvement store purchase some rubber weather stripping. Measure the garage door opening before purchasing panels.