How To Install Corrugated Metal Wall Panels

Start at the end of one wall and use square up.

How to install corrugated metal wall panels.

To install corrugated roofing start by cutting your panels to length with an angle grinder. This will keep the wall straight as you place additional panels. Finally situate the metal sheet onto the drywall and attach to the corrugated metal strips using screws designed for the tin. For vertical installation start at one side of the wall and position the panel at least 1 2 inch off the floor.

Metal panels are made to overlap a few inches in the grooves. Interiors by kenz recommends using tuftex deckdrain fasteners piercing cap washered. Beginning at the outside edge of your roof place each panel directly onto the purlins that are attached to the roof trusses. Corrugated metal wall sheets are usually around 24 to 26 inches wide.

Next pre drill holes on the end and side ridges of the panels spacing the holes 6 to 8 inches apart. When installing metal panels it is vital to get your first panel squared. Raising the panel prevents rusting that can occur if the bottom of the metal gets wet. It will take two people to install the metal panels one to hold the panels in place and the other to insert the screws.

Corrugated metal wall panels are pieces of ribbed metal used to cover or protect a wall.