How To Hold Christmas Lights Up On Wall

These grip onto the narrow horizontal surface at the top front of a brick between the surface of the wall and the grout line.

How to hold christmas lights up on wall.

X research source a 13 64 in 0 52 cm bit corresponds to the smallest type of brick wall plug. To start you re going to want to measure your room and how far apart you want the lights to sag. Again hold it firmly in place for 30 seconds to ensure a proper seal. Slide the coated wire portion of the light strand through a hook in the clip to hold the light strand up.

Press the bottom of the clip to open the top clamp and insert the string into the clamp. Pull the string to the next clip and clip it in in the same fashion. Install one clip every 2 to 3 feet or as needed depending on your light strand layout. Repeat until you have lights along the length of the wall.

Use battery powered lights for simplicity and ease. Keep in mind that there are different sizes of wall plugs you can use but the smallest one is fine for stringing up christmas lights. Either way you can pin the cord leading up to the ceiling to the wall. In the past lights had to be attached to walls using a hammer and nails which often left unsightly holes that needed to be patched up once the lights.

Fasten the lights to exposed brick walls using brick clips. They can be seen on trees in shopping malls indoors outdoors and even hanging from ceilings. Pull the trigger directing a glob of glue onto the cord and wall. Plug your lights into the nearest outlet and run them up your wall to one of the top clips on either side.

Continue attaching double sided tape to your christmas lights and pressing the lights to the wall. Plug the christmas lights into the nearest outlet. Hold the string lights tight so they make a straight line up your wall. String the lights to the closest clip.

If you only measure from one side of the wall to the other you re going to end up with only enough lights to run them flush across the ceiling. Run the lights horizontally to another top hook and wrap it in place. Remove the cover on the remaining side of the tape and press your christmas light against the stucco wall. Press your christmas light against your home.

Place the ladder in the location where your string lights will end and climb the ladder with your lights and glue gun. Place the nozzle of the glue gun close to the light cord being careful not to touch it. Opt for battery lights over electrical lights to make things easier on yourself. Figuring out how to hang up your lights can be tough when you have to worry about whether or not the correct end of the strand will reach an outlet.