How To Hang A Wall Mounted Pot Rack Without Studs

3 finishing nail and a hammer will do the job.

How to hang a wall mounted pot rack without studs.

However the studs don t line up with where i need to install the screws. In most cases tapping a small hole into the wall with a no. How to hang pot rack on drywall without studs. I have a wall mounted pot rack that fits in between two tall cupboards in our kitchen.

Screw the wall anchors clockwise until they are flush with the wall. The most secure way to hang a coat hook wine rack picture or any piece of wall art is to attach a screw to a stud. You want something mounted on the wall that s heavy and going to need proper stud support but the stud isn t in the exact spot you need it. Most structures have vertical studs spaced 16 inches apart.

To hang a pot rack start by using a stud finder to locate the studs in the ceiling. Pass the tip of a pencil through the screw holes on the rack to faintly mark their positions on the wall. Once you find the studs running the 1x2 and screwing to that should be fine when last i mounted a pot rack i used a piece of 3 4x4 wood which i stained first. Studs are pieces of wood beneath the drywall that act as the wall s frame.

If possible plan to hang the rack so it will be securely attached to the wall studs. And why would it be really studs are basically every 16 inside the wall so the odds will not be in your favor to have one exactly where you need it. Next pass the screw through the fixture you re attaching to the wall. Insert a phillips screwdriver into the opening on the anchor s head.

You can also find some that run horizontally. Michael kohne feb 25 13 at 3 07. Make sure it s level with the wall but don t overtighten it or else it could damage the wall. It was in a rental so when i took down the rack i just screwed hooks into the holes and left the wood in place.

Test fit the pot rack on the wall where you want to install it. To install a toggle bolt first drill a hole in the wall large enough for the toggle. Thread the screw partway into the. Make a pilot hole on the wall where the anchor will go.

Then place the pot rack on a piece of cardboard and punch small holes in the cardboard at the points where the chains should hang so you create a template. The pilot hole ensures that the anchor starts its path into the wall smoothly and hits the location you want to mount it at precisely.