How To Hang A Laminated Wall Map

The frame is put onto the back of your plate with the included glue.

How to hang a laminated wall map.

I knew i would have to buy some wallpaper hanging supplies but i didn t anticipate that they would cost almost as much as the mural. If your poster or map is too heavy for this method you can do a similar thing on the front. Pull it out of the tube and lay it on a clean flat surface. Decide where you are hanging your map then measure and mark the wall lightly where the top corners will hit.

Easiest picture hanging ever. The aluminium suspension system can also be used for a rope suspension. The mural is actually three latex coated panels that are hung like wallpaper. You don t need any additional materials.

Then it has to rest for 24 hours before hanging it up. The directions on the package were sufficient for us. Place the command strips along the edges of the foam board s backside. One end of the rope is hooked under the rail of the plate.

Then let the map roll up. Check the fit and alignment. A couple of rolls should do it but please be careful. Use two nails or screws in the wall to hang up your print.

Use tacks but only put the sides of the tacks on it not the point. We ve listed our favourite ways to hang our wall maps below but before you start take a minute to properly prepare your map. Spray the adhesive to half the board then unroll. Put tape on the front of the corners all the way to the edge and then tape it to the wall but put the tape over your laminated corner.