To do this place a 2 x 4 piece of wood under the garage door.
How to force a garage door to close.
If your garage door refuses to close at all there could be a few simple reasons.
Adjust the close force control to change the amount of force your garage door opener uses to close the door.
If your garage door freezes on the way up or if it stops and reverses directions on the way down you may need to increase the force adjustments on your garage door opener.
Locate the open force and close force controls to the right of the travel limit and set buttons on the power head unit control panel.
If you notice any binding the opener will not force the door down.
First check the battery in your garage door opener s remote.
At least that s the theory.
One of the most common causes of a garage door not closing is because the garage door opener isn t getting power.
These are called the limit and force adjusters respectively.
Watch and feel the travel of the door as you close it.
Garage door openers make life convenient.
Close the garage door.
Perform the safety reversing test after adjusting the travel limit.
From inside your garage close your garage door.
If your garage door is not coming down all the way or if you have a garage door closing and then bouncing back up you may have to adjust your.
You ll never need to step outside to get your car in or out of the garage again.
How to adjust a garage door to close completely.
Loosen the bolt that secures the door track bracket to the wall with a socket wrench and pull the track away from the door edge slightly nearest the binding area.
This video from sears partsdirect shows how to check the garage door for smooth travel adjust force settings and test the new settings to make sure the door closes safely.
A garage door opener with an improperly adjusted closing force can damage the door or worse injure a child or pet that accidentally walks under the door.
At this point you have to tweak the down travel adjustment dial till the garage door fully closes without reversing.
Check the space under the bottom door edge to be sure it is tight against the floor surface.
Close the garage door.
If the garage door reverses repeat step 2 and 3.
The closing force of the door works as a.
Tighten the track bracket bolt with the socket wrench.